Rated voltage 24 V DC
range 0 ... 255 Lux, linear
The brightness sensor is used for the measuring and evaluation of the brightness.
The dawn sensor is used for the measuring and evaluation of the brightness (dawn/dusk).
The temperature sensor is used for the measuring and evaluation of the temperature.
The value measured by the sensor is transmitted to an analogue output signal of 0 V – 10 V by the electronics.
Connections:Plasting housing with PG7 thread + screw and pressure respectively moisture compensation (recommended cable 3 x 0.25 mm
2)
+UB: operating voltage24 V DC
GND: corresponding ground
OUT: output 0 ... 10 V
| Technical data |
|
| Supply voltage: |
24 V DC (15 ... 30 V DC) |
| Connection: |
screw terminals |
| Terminals for: |
2.5 mm2 |
| Connecting cable: |
through screwed conduit entry PG 7 |
| Recommended cable: |
3 x 0,25 mm2 |
| Cable length: |
max. 100 m |
| Output: |
0 ... 10 V DC (into a load of at least 1 kΩ, shortcircuit protected) |
| Ambient temperature: |
–30 ... +70 °C |
| Protection level: |
IP 65 |
| Mounting position: |
optional |
