Rated voltage 24 V DC range 0 ... 60000 Lux, linear
The brightness sensor is used for the measuring and evaluation of the brightness. The dawn sensor is used for the measuring and evaluation of the brightness (dawn/dusk). The temperature sensor is used for the measuring and evaluation of the temperature. The value measured by the sensor is transmitted to an analogue output signal of 0 V – 10 V by the electronics. Connections: Plasting housing with PG7 thread + screw and pressure respectively moisture compensation (recommended cable 3 x 0.25 mm2) +UB: operating voltage24 V DC GND: corresponding ground OUT: output 0 ... 10 V
Technical data
Supply voltage:
24 V DC (15 ... 30 V DC)
Connection:
screw terminals
Terminals for:
2.5 mm2
Connecting cable:
through screwed conduit entry PG 7
Recommended cable:
3 x 0,25 mm2
Cable length:
max. 100 m
Output:
0 ... 10 V DC (into a load of at least 1 kΩ, shortcircuit protected)
