Installation in the 230V power supply cord of standard lamps and bedside lights.

100mm long, 50mm wide and 25mm deep.

Supplied colours: pure white, black and anthracite.

This wireless actuator is an impulse switch with integrated relay function and features

state-of-the-art hybrid technology that we developed: we combined the wear-free receiver

and evaluation electronics and a bistable relay with zero passage switching.

By using a bistable relay coil power loss and heating is avoided even in the on mode.

With the rotary switch on the side

in the settings LRN up to 35 wireless pushbuttons

can be assigned, of which one or more central control pushbuttons. In addition, wireless

motion/brightness sensor FBH and/or a wireless outside brightness sensor FAH for a presence

simulation. The required function of the impulse switch with integrated relay function can then

be selected:

ES = Impulse switch

After the FBH is taught-in, the device switches on when movement is detected and, after

an additional FAH is taught-in, at twilight and when movement is detected.

If no movement is detected, the contact opens after a 4 minute delay. A wireless switch

can only be taught-in additionally to activate or deactivate presence simulation.

ER = Switching relay

When FAH is taught-in, the device switches on at twilight.

The contact opens after a 4 minute delay when brightness is detected.

AS = Presence simulation

The AS starts with a random pause time of 20 to 40 minutes followed by a random

switch-on time of 30 to 120 minutes.

When the rotary switch is turned to AS or when the line voltage is switched on in AS

position, the light switches on for 5 seconds after 1 second.

When the FAH is taught-in, the AS only starts when twilight commences.

After the FAH detects brightness, the AS ends after 4 minutes.

The LED

on the side below the left rotary switch accompanies the teach-in process as

described in the operation manual. It indicates control commands by short fl ickering during

operation.