Modular device for DIN-EN 60715 TH35 rail mounting.

1 module = 18mm wide, 58mm deep.

Connection to the Eltako RS485 bus, terminals RSA and RSB.

Up to a total of 128 actuators can be added in this way.

Up to 35 pushbuttons each with 4 functions can be assigned to each channel, of which one

or more central pushbuttons.

Switching voltage 230V.

Zero passage switching to protect contacts and consumers.

The upper rotary switch AV

is required for teach-in. Then set here the response lag time AV

between 0 and 120 seconds for Contact L-1.

The middle rotary switch

is required for teach-in. Then defi ne here the response after a power

failure. In position AUTO1 the switch position is retained; in position AUTO2, the device is

switched off according to a defi ned procedure.

Use the bottom rotary switch RV

to set the time delay time RV between 0 and 120 seconds

for Contact L-1.

The AV and RV times permit the simple control of lights and air conditioning systems.

The response lag AV starts as soon as the hotel card/key card is inserted in the wireless

card-operated door lock FKF and the time delay RV starts after the card is removed.

In addition to the wireless card switch FKF, wireless window/door contacts FTK, Hoppe window

handles and motion/brightness sensor FBH can also be taught in.

Opening a monitored window also starts the RV time. When the RV time expires, Contact L-1

opens. Closing all monitored windows starts the AV time. When the AV time expires, Contact L-1

closes.

When motion/brightness sensors are used and the hotel card/key card is inserted, Contact L-1

closes immediately motion is detected. If no motion is detected for 15 minutes the contact

opens, even if the hotel card/key card is inserted.

The LED

below the upper function rotary switch performs during the teach-in process according

to the operation manual. It shows control commands by short flickering during operation.