Power supply either with solar cell module FSZ55 or with switching power supply unit

SNT61-230V/12V DC.

The scope of supply includes a frame R, an intermediate frame ZR in the same colour, a

mounting plate and an adhesive film. In addition, an intermediate frame ZRF in the same

colour is supplied for installation in an existing frame R1F, R2F or R3F for flat pushbuttons.

The switch mode power supply SNT61-230V/12V DC must then provide the power supply.

The motion/brightness sensor FBH55 requires no installation depth behind the mounting plate.

It measures from 0 to 2000 lux and transmits a message to the Eltako wireless network

every 100 seconds if the brightness changes by min 10 lux. If the sensor detects motion,

it sends a signal twice immediately.

The switch-off signal is sent after the off delay which has a fixed setting of 1 minute.

If there is no change, a status message is sent every 20 minutes.

When teaching-in actuators, the switching threshold is defined for switching the light

on/off depending on the brightness. Additional variables are also taught-in on the FKR12.

When an FBH detects movement, switching takes place then and time delay only starts

when all FBHs taught-in in an actuator detect no more movement.

When mounted on the wall the detection angle is >120° and the range is approx. 10m.

When mounted on the ceiling the diameter on the floor is approx. 8m for a ceiling height

of 2.5m.

* The bottom of the housing is matt.