The electronic requires no intrinsic power supply, so there is no standby loss.

The wireless outdoor brightness sensor FAH63 powered by a solar module covers the range

from 0 to 30000 Lux. From approx. 300 Lux, it transmits a wireless telegram to the Eltako

wireless network every time there is a brightness change of more than approx. 500 Lux within

approx. 10 seconds. If the brightness does not change, a control signal is sent approx. every

100 seconds.

New actuators FSR and FSB can cover the range from 0 to approx. 30 Lux using the twilight

switch function. A wireless telegram is sent about every 100 seconds within this range.

In as-delivered state the energy accumulators are empty and must therefore be charged in bright

daylight for approx. 5 hours.

In normal ambient brightness (at least a daily average of 200 Lux), the energy of the integrated

solar module is sufficient to power the FAH63. The sensor requires no installation depth behind

the mounting plate and can be screwed or glued to any flat surface. An adhesive film is supplied.

The power reserve stored in capacitors supplies the power requirement for the night.

The complete module can be removed from the frame for screw mounting.

To teach-in

in an actuator in teach-in mode, hold the supplied blue magnet or any other magnet

at hand below the point on the side panel of the sensor marked by