In as-delivered state the energy accumulators are empty and must be charged in bright

daylight for about 5 hours.

In normal ambient brightness (at least a daily average of 200 Lux), the energy of the

integrated solar module is sufficient to power the FABH63.

The sensor requires no installation depth behind the mounting plate and can be screwed

or stuck to any flat surface. An adhesive film is supplied.

The power reserve stored in capacitors supplies the power requirement for the night.

To teach-in

in an actuator in teach-in mode, hold the supplied blue magnet or any other

magnet at hand below the point on the side panel of the sensor marked by

■. This sends

a teach-in telegram.

The sensor transmits a message to the Eltako wireless network every 100 seconds if the

brightness changes by min 10lux. If the sensor detects motion, it sends a signal twice

immediately. The switch-off signal is sent after the off delay which has a fixed setting of

1 minute. If there is no change, a status message is sent every 20 minutes.

When teaching-in in actuators, the switching threshold is defined for switching the light

on/off depending on the brightness. Additional variables are also taught-in on the FKR12.

If a FABH63 detects motion, then the device is switched on and only when all the

FABH63s taught-in in an actuator fail to detect motion for one minute, the actuator return

delay starts if this was previously set.