The wireless transmitter module FASM60-UC has two channels and, like a wireless pushbutton,

it can transmit local and central control signals into the Eltako wireless network.

The signal on opening the two control contacts is identical.

Severel wireless transmitter modules must not be switched at the same time.

There is a screw joint M12 at the bottom for the waterproof connection IP54.

Connection to a 5-fold inside terminal for the control input

+A1/-A2 and +A3/-A2. Loosen the 2 screws on the front and remove lid.

If the terminals A1 and A3 are connected with a bridge, the control signal is transmitted once

per minute, provided the control voltage is applied, e.g. for central commands with priority.

The universal control voltage processes control commands of 8 to 253V AC or 10 to 230V DC

with periods lasting min. 0.2 seconds.

Max. parallel capacitance of the single control leads (separately installed) at 230V 3nF, this

corresponds to a lenght of approx. 10 meters. Parallel control leads (jointly installed) at 230V

0.5nF, approx. 2 meters. Max. parallel capacitance (approx. length) of control lead at 12-24V UC

0.03μF, this corresponds to a lenght of approx. 100 meters.

No permanent power supply required, therefore no standby losses.